Advanced Convertamatic X26D-C
Advanced Convertamatic X26D-C
This machine is a fully refurbished Advanced Convertamatic X26D-C with AXP detergent dispensing system. The AXP system precisely measures detergent according to the manufactures dilution ratio and applied it to the floor with clean water at the scrub heads. This eliminates detergent in the solution tank. The 26 inch scrub deck is powered by a disk driver. The machine has been inspected and tested to ensure optimal performance. Wearable parts are inspected and replaced as needed.
All Convertamatics come standard with an integrated Smart Solutions™ system that allows the machine to operate for 1 hour and 20 minutes per dump & refill cycle with the Convertamatic’s 20 gallon (76 L) solution and recovery tanks. At the same time, the integrated Smart Solutions™ system features pre-set scrub settings that combine solution flow and scrub pressure into simple operator selections for regular, heavy, or extreme scrubbing conditions. The combination of these features makes the Convertamatic® the ultimate in One-Touch™ operation for instant training, increased safety, consistent performance, and maximum run-time.
Key features:
- 26 inch scrub deck
- Disc driver
- 20 gallon solution tank
- 20 gallon recovery tank
- AXP detergent dispensing
- Soft touch paddle system
- Ultra flow squeegee.
- Non marking tires
- Click-off scrub heads
Read more about our refurbishing process below:
What is the difference between buying a used machine versus a SERVICESTAR certified reconditioned machine?
There is actually a big difference between the two. When you hear the word "reconditioned," you may think of something pre-owned. A pre-owned used machine is exactly how it sounds. A machine that was used by someone else without the knowledge of it working properly or not. However, there is so much more that goes into reconditioning a machine at SERVICESTAR. Our goal when reconditioning a unit is to bring the function as close to brand new as possible.
Our refurbished machines adhere to a strict refurbishment program and the work is performed by factory trained technicians. We focus on quality control standards to ensure the equipment exceeds your expectations.
All equipment is restored to fully operational condition through a rigorous 5-step process:
- Inspection: All equipment is inspected for electronics, electro mechanics and hydraulic operations.
- Disassembly: Every unit is disassembled for thorough inspection and cleaning.
- Replacement of Suspect Parts: All electronic boards, power supplies and electronic components are tested and replaced if needed. Valves, cables, squeegees, solution and recovery lines and other worn parts are replaced to guarantee top performance of the refurbished equipment.
- Reassembly and Testing: The equipment is then reassembled and tested on the floor to ensure optimal performance.
To ensure a thorough job is done, each machine takes on average 15 to 30 hours to recondition.